The "FIND" option is seen when there would be more number of configurations.
In your case, if you had configured more(~100) user ids in your cucm, you will see FIND option.
For example: we see 'FIND' opition below for DEVICE POOL in phone config page, since i had more number of device pools configured.
see below screenshot.
... View more
Configure below: dial-peer voice 200 voip incoming called-number . no vad dial-peer voice 300 voip ---->this is the dial-p towards CUCM session protocol sipv2 session target ipv4:192.168.50.10 ( CUCM IP address ) destination pattern 0822877730.......----> mention here the range of CUCM DN's. For incoming through this SIP trunk to reach CUCM DN's, provider will send some number, you need to configure accordingly in above dial-peer voice 300. If your CUCM DNs are in range 21559 to 21889, you can configure in above dial-peer 300, destination-pattern as 21xxx. If provoider is sending fufl DID number towards CUBE for incoming call, like 21246421559, then configure in above dial-peer 300, destination-pattern as 21246421xxx, then in the CUCM you can configure translation pattern to convert 21246421xxx to 21xxx, so that it rings phones with DNs 21xxx range in CUCM. dial-peer voice 100 voip ---->this is the dial-p towards SIP provider destination-pattern 082....... ---->mention here the range for outgoing calls towards SIP provider. session protocol sipv2 session target ipv4:10.1.45.20 dtmf-relay rtp-nte no vad In the above dial-peer 100, mention the range for outgoing calls, the called numbers range which will be sent out from CUCBE towards SIP provider. ++++From debugs, CUBE is sending INvite Via 192.168.50.1, since you have given bind for media and signalling as GigabitEthernet0/1. Sent: INVITE sip:firstname.lastname@example.org:5060 SIP/2.0 Via: SIP/2.0/UDP 192.168.50.1 As you mentioned in your earlier note: Signalling IP: 10.1.45.3(GigabitEthernet0/0) ( this is the IP they ask from us to be used for signalling) Make below change: conf t voice service voip sip bind control source-interface GigabitEthernet0/0 bind media source-interface GigabitEthernet0/0 Router# wr mem
... View more