Hi all, I'm running a 1900 series as our boarder edge router, One of the ethernet ports of this router is configured as router on a stick. Plugged into the switch I have a 2811 running CME 8 separately. The link appears to keep dropping between the c...
Hi All,I've been trying to figure out how to enable incoming calls on CME with a sip trunk. Our CME is behind another border edge router, hence the ip route command in my config. I'd like to have our DID number ring a group of our phones, but Can't ...
Hi all.
Had some very strange issues this evening.
I have a 2960 Switch that only seems to like certain devices being plugged into it.
For example, I tried plugging two different laptops into a few different ports, namely port 4, 5, 6, but no ...
Hi everybody.
I have a Cisco 2811 router with one Fastethernet L3 port in trunk mode, with sub interfaces, and a switch connected at the end with Vlans set up in another room.
I had planned to use the gigabit port on a NM-ESW-16 module to creat...
Hi all.
I have a cisco 2811 behind a bridged broadband modem. The link is configured on one of the router ports is DHCP.
I have an ACL on this port that denies all traffic coming inbound, as well as CBAC enabled to inspect traffic going outbo...
Hey Roger, Thankyou so much for your help. As you mentioned, I think it may have been these commands that may have been causing an issue, so I added the reverse of them with the (no) infront;dial-peer voice 1000 voip no permission term no session tar...
Hey Roger thanks again for your reply, So basically what I’m doing is I have a network termination unit modem for our Internet service and then that is bridged into a Cisco router that I have with Nat translation switched on between the wide area net...
Hi Roger thanks for your replies, Sorry for the confusion, The IP required is listed there, it's just I replaced the ip address in the logs with an alias to hide the real one from the public viewing these posts. This should be all corrected now. A...
Sorry forgot to post the output Received:INVITE sip:61285647585@202.36.52.125 SIP/2.0Via: SIP/2.0/UDP 202.36.52.125:5060;branch=z9hG4bK515002d3;rportMax-Forwards: 70From: <sip:0485945256@sip.simtex.com.au>;tag=as7559ce03To: <sip:61285647585@202.36...
Hi,
This problem resolved it's self when I arrived at this site to fix the problem.
I'm rather confident it's being hacked.
We have had quite alot of people playing games on our system, possibly some kid down the road with a long range WiFi ant...
