hello Guys , i have an issue with our cucm 10.5 with my mx series endpoints , once the unisite endpoints are registered to the cucm it is not able to do video calls but once not registered it can do at least P2P video calls ?what could be the issue g...

hallo alli tend to see an E164 number & alias names on my mcu and was wondering if i configure these credentials to the video kits and register the mcu to the VCSc this should allow for multisite functionality and call management from the MCU?  

hello i have an environment with 5 VC kits along with 4505 mcu, vcsc and tms , my VC kits are all unisite so are tied to the mcu for mutisite calls routing through the VCS-C and monitored from the tms. while on a call my VCS-C went dead and that affe...

hello pls , i have an infrastructure comprising: MCU, VCSc, TMS and 5 endpoints. now my VCSc wont even come up so i decided to do direct calls on the 5 video kitsbut my question is can i do my calls booking from my TMS with IP addresses since alias  ...

hello All,pls can NAT on a C40 codec registered on a VCSc allowoutbound calls without using the VCSe papa