Is it supported to export All Configuration from a 6248 domain and import into a 6454 domain? Are there firmware restrictions? Let's assume the 6248s are running slightly older firmware than the fully updated 6454s. I can't find this exact scenario i...
So I'm tracking on how the default VLAN 1 is allowed on all uplinks in Disjointed L2 Network configs, but what if VLAN 1 was not the default or Native VLAN on the UCS? What if we used a different Native VLAN and started tagging VLAN 1? Is the rule th...
The B200 M4 blades shipped with 7.0 board controller firmware and the UCS Mini shipped with the latest 3.0(2c) code. Once a Service Profile is associated, the activation of the 7.0 board controller firmware fails. The 3.0(2c) blade firmware package...
I'm standing up a couple separate UCS Mini domains, each with two B200 M4 blades. The UCS Mini ships with the latest 3.0(2c) code and the B200 M4 blades are shipping with version 7.0 board controller firmware. This configuration causes a major even...
We have a production 2224 FEX attached to a Nexus 5020. A power supply has gone bad in the FEX and we've received a replacement 2224. Again, the 5020 and 2224 are configured and in production. How do we replace the 2224? So, the hardware installa...
Thanks for sharing. v2.5 needs updating to support the Intel Scalable Processors found with B200 M5 blades, for example. In the meantime, I just commented out the CPU model parsing on line 787 Works a charm.
Ok, I think I understand. It sounds like there's no way to trunk VLAN 1 only over one set of uplinks in a Disjointed Layer 2 Network, whether or not VLAN 1 is tagged or untagged or whether we use a different native VLAN or not. Is that correct?
Is VLAN 1 still trunked on all uplinks in a DL2 network if I start tagging it? Let's say I set VLAN 20 as the Native VLAN and begin tagging VLAN 1. Is VLAN 1 still trunked on all uplinks in the DL2 networks?
Hi Brent,I posted in the support community and received a good reply. Basically, use the "force" option from the CLI.https://supportforums.cisco.com/discussion/12571651/activation-failed-b200-m4-70-board-controller-firmware-ucs-mini-302cAll the best...
