About sveinbarlund

sveinbarlund · 05-28-2014

I have set up two 3925 in a hot-standby configuration.If i configure track with IP SLA, the IP SLA stops probing (ping) as soon as at least one interface goes to standby. IP SLA probes are declared Down. If all standby interfaces go to Active (by ma...

sveinbarlund · 07-03-2018

Do you have DSP resources in your 4331 ? I recently struggeled a few hours getting ISDN PRI (E1) working on the 4331. Found that I had to install the DSP module on the E1 card (moved from motherboard). I am however not sure of the DSP install requi...

sveinbarlund · 06-10-2014

I think I am on to something: If I remove the redundancy inter-device configuration from at least one of the routers, the ip sla works as expected. DELETED: redundancy inter-device DELETED: scheme standby HSRP1 ! redundancy ! ! ipc zone default as...

sveinbarlund · 06-06-2014

I have checked and double checked all your suggestions.The strange thing is that ANY ip sla probing stops, even to an internal interface, when HSRP interface(s) go to standby state. I have now tried with a different IOS version: 15.2(4)M6, but still...

sveinbarlund · 06-02-2014

Below is my HSRP and IP SLA config. HSRP with preemption is working, except for the intended ip sla priority manipulation. The problem is only that IP SLA stops sending out PING probes and declares Down state when one or more HSRP interfaces go to ...

Member Since	‎05-26-2014 11:14 PM
Date Last Visited	‎01-13-2021 12:13 AM
Posts	6

User Statistics

User Activity

IP SLA stops probing when one or more interfaces goes to standby

Re: Voice using NIM-2BRI-NT/TE on ISR4321 IOS XE Software, Version 16.06.03

I think I am on to something:

I have checked and double

Below is my HSRP and IP SLA