About tca_arosen

tca_arosen · 09-19-2014

Hello extremely knowledgeable and helpful community that will surely figure out how to fix my problem (is that enough flattery?)We have a CUCM 9.x with a CUBE 2911 set up with a SIP trunk to our provider. As a backup solution (which I was told would ...

tca_arosen · 05-30-2014

I have been having problems getting faxing over T38 working and I am wondering if my understanding of the protocol is part of the issue. Our scenario is:ITSP >>>>SIP>>>> CUBE 2911 >>>>SIP>>>> CUCM 9.1.2 |-> FXS...

tca_arosen · 05-30-2014

Hello all - I'm new to CUCM and I am installing my first phone firmware pack since we had our CUCM install done. Following instructions at http://www.cisco.com/web/software/282074288/113778/cmterm-7821_7841_7861-sip.10-1-1SR2-readme.html. When I try ...

tca_arosen · 05-27-2014

I am trying to get a pause in a speed dial to work on an 8945 IP Phone. I have configured the speed dial to dial 1234567,,129. After connecting the main number, I hear a quick "beep-beep" where the DTMF tones should be transmitted. Is there some sett...

tca_arosen · 05-21-2015

Mark - I had a Cisco tech help out with this. It looks like Avtec is using KPML (and I don't think that's in keeping with RFC2833). We had to change the "DTMF Signaling Method" on the trunk configuration to "OOB or RFC2833". I think you also need to ...

tca_arosen · 03-04-2015

Mark - We are having this issue as well with our new Avtec consoles. Did you get this resolved, and if so, can you point me in the right direction?ThanksAdam

tca_arosen · 09-22-2014

I just want to thank everyone for their input so far. I am trying to get RTMT up and running. I've had it work in the past, but right now when I run it I am getting "RTMT failed to initialize. Exiting...". I'll post an update once I can make some pro...

tca_arosen · 09-19-2014

Correct, CUBE is only being used for the primary connection.

tca_arosen · 09-19-2014

Ahhh, the fun just keeps on coming. Just to clarify, we do have a CUBE for primary connectivity - the SIP trunk terminating at CUCM is just for failover purposes so we don't need to have a second CUBE in our infrastructure. I think I need a drink.

Member Since	‎05-27-2014 09:51 AM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	21

User Statistics

User Activity

CUCM SIP trunk header issue

Question regarding T38

Restricted/Unrestricted warning on IP phone firmware upgrade

Pause in speed dial CUCM 9.1 - issue with DTMF tones

Mark - I had a Cisco tech

Mark - We are having this

I just want to thank everyone

Correct, CUBE is only being

Ahhh, the fun just keeps on