We're on Everest 16.6.2 (Cat9300-24T-A) and we're seeing this same issue Cisco IOS XE Software, Version 16.06.02Cisco IOS Software [Everest], Catalyst L3 Switch Software (CAT9K_IOSXE), Version 16.6.2, RELEASE SOFTWARE (fc2) show platform hardware fed...
Hi all,Please see attached diagram for clarity. i have a multipod environment (2 pods). in each pod, i use a static default route to a local firewall, and leaf switches in each pod send default traffic to the local exit point, as you'd expect. if i t...
Hi,
I have 2 pods, with 1 L3out, with interfaces profiles connecting to a firewall in each pod (for external access), topology like this:
===Cloud provider===
| | (bgp)
fw1 fw2
| | (ospf, singl...
Hi there.
i have a setup where i have 2 separate firewalls connected on the same vlan and subnet with an SVI on a Cat6500. It is a transit vlan with 3 exit points. The 2 firewalls can also route directly to each other.Bad drawing attempt:
---------...
Hi,
Could someone answer these questions definitively please, and correct me if I'm wrong. I've read all sorts of documentation and can't seem to extract the answers i need.
The Nexus 9k does not seem to be capable of WCCP. Is this true?
It is capa...
I've come up against this problem a few times, most recently when contracting between VRFs (in the same Tenant).I want vzany in tenant-x:vrf1 to offer a shared contract (e.g. admin access to servers on port 22).An EPG in tenant-x:vrf2 will then consu...
Thanks for your answer Michael.
I am using only a single L3out.
I think if i had 2 L3outs, then i would have to add the same route (10.10.10/24) to both L3out EPGs.
When i've attempted this in the past, ACI raises a fault regarding the overlap.
Hi,
I have the same problem.
SNMP to the 9ks works, to the APIC it doesn't.
I've followed all the instructions in this document (twice!):
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/mib/guide/b_Cisco_ACI_MIB_Quick_Re...
How is the NTP server configured?
I've followed the instructions here, which aren't very clear.
I have this on my leaf node:
LEAF-01# show ntp server-info
ServerState: enabled
MasterMode : disabled Stratum : 8
If i configure a pervas...