About ypakhomenko

ypakhomenko · 04-08-2015

866VAE-K9 Modem/AUX ProblemHi Everyone,I am currently observing some strange behavior of 866VAE-K9 router which might be a bug or my mistake, so I would very much appreciate your suggestions...The 866VAE-K9 router has a single physical AUX/CON port.T...

ypakhomenko · 03-30-2015

Hello everyone,I need to build a resilient VPN solution based on the CISCO 866 VAE-K9 routers,I have: three sites, each has one DSL and one analogue telephone line,two of them have a static and known IP from their ISP, one will be assigned someIP eve...

ypakhomenko · 06-17-2014

Hi All,I noticed the following behaviour that I cannot understand,I would very much appreciate if you could explain it to me || give me a tip where to look for it...there is an ARP entry for the 192.168.1.1 address:sh arp Protocol Ad...

ypakhomenko · 04-08-2015

forgot the config: line con 0 exec-timeout 0 0 login local modem enable escape-character BREAK stopbits 1line aux 0 exec-timeout 0 0 modem InOut no exec transport input all escape-character BREAK stopbits 1 speed 115200 flowcontrol hardware

ypakhomenko · 04-01-2015

Hi, thanks a lot for your answer,would you suggest to ping the public IPs of the routers,the IP of the GRE tunnel or some internal IP available overVPN/GRE? (for me the last one sounds the best)

ypakhomenko · 06-17-2014

P.S.only if I shut / no shut the f0/0 interface the ARP table is cleared as expected...

Member Since	‎06-17-2014 07:48 AM
Date Last Visited	‎08-18-2017 04:01 AM
Posts	7

User Statistics

User Activity

866VAE-K9 Modem/AUX and rev. telnet Problem

Resilient VPN configuration on c866 VAE-K9

Magical ARP entry?

forgot the config: line con 0

Hi, thanks a lot for your

P.S.only if I shut / no shut