Hello Steve, Each time you will launch a simulation the management IP will get changed because we are not assigning it manually, it used to get from pool IP address configured in settings.ini which is the normal behavior of CML. Thanks and Regards, B...

Hello, I assume you have raised a case SR 637384225 for the same, which is resolved today over the WebEx session. Thanks and Regards, Bikash

Hello,You are correct, the pool will be back after stopping the simulation i.e when you stop the simulation the nodes will be released to give the pool again 15. All the users can use maximum 15 nodes collectively.   About the requirement and specifi...

Hello, Kindly contact your account manager for the future release details. Thanks and Regards,Bikash 

Hello Saurav, Are you getting this issue in Cisco Modeling Lab environment. Thanks and Regards,Bikash