luchonat1
Level 1
Level 1
Member since ‎07-02-2014
‎05-22-2019

User Statistics

  • 28 Posts
  • 2 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
1 Accepted Solution
20 Replies
10 Replies
5 Replies

User Activity

Ok, so I have a set up of eight WAP 371 in single point setup, and four different wireless networks configured in each radio (4 in 2.4GHZ and 4 in 5GHZ). Problem is that after a few hours of work devices stop connecting to the AP's. If the radio is d...
Hello Experts! I'm having a lot of trouble to finish a router config. The problem is with static nat/pat. The scenario has three different ISP's. Two of them are always load balancing the general internet access (NAT overload), and the third is dedic...
Ok, here's my scenario: I have a router with various local VLAN's and a nat statement to a host:port allowing it to be reachable from the outside (for example port 80).   Assuming: w.x.y.z is a host in vlan 10 a.b.c.d is a host in vlan 11 A.B.C.D is ...
Hello everybody! I have this scenario: My main router is a 1921 ISR Multiple local networks assigned to multiple VLAN's, and connected to three Internet Providers. This providers are just standard services (three different cable providers), so I have...
Hello people!   I have the following problem:   I have a 1921 router, connected to two ISP's, no routing exchanged with this ISP's just simple internet services. I've configured nat and cef, so traffic is being load-shared with this two ISP's. Over o...
Community Statistics
Member Since ‎07-02-2014 07:25 PM
Date Last Visited ‎05-22-2019 12:07 AM
Posts 28