About BalajiDasarathan

BalajiDasarathan · 01-30-2015

In my Nexus 7010 infrastructure, I have a requirement to redistribute host routes in to OSPF so that the other connected sites receive the host routes through OSPF.These hosts are part of the connected network (192.168.100.0/24) on Nexus, I dont want...

BalajiDasarathan · 08-05-2014

Dear MembersI would like to configure the gig0/0 (Management port) on Cisco 3850 switch for TACACS authentication, however, the TACACS authentication doesnt work and the switch can only do local authentication.The below link doesnt include TACACS as ...

BalajiDasarathan · 07-14-2014

HiI am spanning multiple vlans as source with the destination as a single ethernet port, though I am able to see the traffic from the VLANs, I am not able to see the VLAN tag in the packet which is a key requirement for me for monitoring.Does anyone ...

BalajiDasarathan · 07-03-2014

Hello allI am setting up a lab to emulate OTV network with 2 Nexus 7010, each with a M2 and F2e module. I created three VDCs in both the Nexus 7010, one for SVI, one for OTV and one for WAN connectivity and am able to ping from one OTV to other (Nexu...

BalajiDasarathan · 01-30-2015

Bilal, It looks like your solution might work for me, however, I am finding some challenges, the route does show up in the OSPF and the routing table, but for some reason, I am not able to get the ping through. I am checking on what could be the prob...

BalajiDasarathan · 01-30-2015

Thanks Jon, I did go through the other thread, a good solution, it probably might work for me. Let me give it a try and will update this thread.

BalajiDasarathan · 01-30-2015

Thanks Reza, I tried the access list route before I posted this question, it doesn't work. :(

BalajiDasarathan · 01-30-2015

Thanks Jon, the routing table doesn't have the routes for the hosts as they are part of the connected network. Yes, I do understand that if I can't have them in the routing table, I cant have them redistributed in to OSPF.It looks like I am hitting a...

BalajiDasarathan · 08-07-2014

Thanks for your response Rolf, we were intending to use this as "in-band" management and because it doesn't support TACACS and has limited SNMP capability, we have dropped the plan of using it as "in-band" management, I wish Cisco could have named th...

Member Since	‎07-03-2014 12:43 PM
Date Last Visited	‎06-19-2018 10:50 PM
Posts	26

User Statistics

User Activity

Nexus 7010 - redistribute host routes in to OSPF

tacacs configuration on gig0/0 Management port on cisco 3850

vlan tag preservation span monitoring

Nexus 7000 OTV site vlan down

Hi Jon I haven't posted

Thanks Jon, I did go through

Thanks Reza, I tried the

Thanks Jon, the routing table

Thanks for your response Rolf