Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,How can i map one of the PSTN number from E1 connection to specific extension on cucm 10.5 for incoming and outgoing.call path as follows PSTN(E1) -->C2921 router(h323) ---> CUCM 10.5 ---> IP phone (ext.1010) 0855345621 --->1010 ...
Dear All, I'm going to implement SRST for remote site on 2921 router.Need to help on separate PVDM3-32 installationSRST license installation (FL-CME-SRST-25)I hope configuration on router side should be -call-manager-fallbackip source-address X.X.X.X...
Hi,Im going to upgrade my cucm 8.6.2 (UCS C220 esxi 5.0) to 10.5 using pcd. What are the require file for this process from below list or let me know if required another. ciscocm.refresh_upgrade_v1.5.cop.sgnUCSInstall_UCOS_10.5.1.10000-7.sgn.isohtt...
Hi All,Cannot log in to 6921 phone using IP address after upgrading new fw Previous Fw - sccp 9.2.1.0New FW - sccp-9-41-3SR1Call Manager - 8.6.2Tried with different browser tried with disable and enable web access on phone config.Can access web with ...
Hi,I'm using E1 on 2921 router for external calls from CUCM.I need to route external calls from one internal ext.(3488) via only specific channel.(channel-18)Reason to do that is telco will assign the caller ID for external call base on Line circuit ...
planing to assign one DID to uccx IVR for all incoming calls which can use as a pilot number for all extension.external party will dial that pilot number followed by extension.another DID for FAXrest of the DID i will assign different extensions as r...
I need to move the e1 to voice router first and also need to map one of the DID with one specific extensionDID range 84463805 -84463829extension range (1-9)xxx Thanks,
