Hi, need help to understand what my problem is? Airplay situation is as follows:Wireless to wireless devices - working fineWireless to wired devices - working fineWired to wired devices - working fineWired to wirelss - NOT workingAny advise on what s...
Hi, I have a hunt group that works fine as long as the phones are online but fails when one of the phones (DN 107) is disconnected (via wireless) from CUCM. Is there any way I can do to allow the hunt group to continue even if one of the phones in th...
any idea why iphones and ipads are not connecting to 802.11ac? it is always connecting to 802.11n. even if i turn-off wifi off and then on, it is sticking with N. anyway i can configure the controller to allow these devices to always connect to AC?
...
Anybody knows or have any experience with prototype switches from cisco? I am looking at getting this for my home lab but have no idea if it is worth it or not.Cisco SG350XG-2F10 10 10GE 2 10GE SFP+this switch has been sold before as-is condition and...
Channel width always goes down from 80Mhz to 40Mhz after a few days, is there anyway I can prevent this from happening? It only happens to one AP, others have no problem.
Just a follow-up, so I have solved this issue by moving my 7921g wireless phones from 5ghz to 2.4ghz and now all devices are able to connect to 802.11ac. Problem now is these 7921g phones is always disconnecting from wireless network "leaving service...
phones are iphone 7 and 8, ipads are a little older i think ipad air but shouldn't have any problem with their NICs as they used to connect through 802.11ac before.
tests done with open authentication have the same results sadly. i did try to chang...
yes, wpa and wpa2 are enabled. i have tried with open authentication local web policy and the result is still the same.
i didn't have these problems before and i used to connect to ac just fine so it just surprised me that i can no longer connect t...
