Hoping to find a better solution with the implementation of Route-Maps, any advice will be appreciated Here is the scenarioI am running Cisco 887VAG routers, which gives you an ADSL connection & a Cellular (3G) connection.In my scenario the ADSL conn...
I have a problem with a new Catalyst 4506E with SUP8EI entered an incorrect config-register when I disabled password recovery, should be 0x2102, I entered 0x2302 Rebooted the switch and it's now in a infinite booting loop with no option to enter ROMM...
Good day I'm trying to configure DHCP option 242 on a "Cisco" SG500x switch for Avaya phones that will be connecting to the switchI have learnt (the hard way) that the SG500X "IOS" is different to what we are used to ...Option 242 works perfectly on ...
I know this is very old, but just had the same issue and found this post when I searched the error.
The issue is aaa authentication, see log below
%ASA-6-605004: Login denied from 192.168.199.201/55819 to management:192.168.199.100/ssh for user "**...
Just an update, still waiting for telecoms company to supply more info on reliability of the next hopMarkin theory and in 1 instance your recommendation worked, but at this stage it's not the complete solutionRegards
Doesn't have to be the same on both sidesOn your HUB change MTU to 1300, adjust-mss to 1260 on the tunnel interface, not the physical interfaceEIGRP is pushing lots of route updatesgive it 15 minutes and then up the MTU and adjust mss again I prefer ...
Josehow will a static route help with the route-map and setting the interface in the route-map No default routing is used/allowed.The route-map basically decides, based on a ACL, if traffic is allowed to go out the Dialer/Cellular interface.In this c...
