About nickrezac

nickrezac · 08-05-2014

I just purchased a new 2960S-48LPS-L. I can't upgrade it past 15.0.1-SE3. If I try to go any newer with the firmware it gives a licensing error. Then it boots into a cut mode of the IOS. Below is a copy of the licensing error after it boots to a newe...

nickrezac · 08-07-2014

This is a fixed switch and the licensing is, for lack of better terminology, fixed itself to the Lanbase license. The firmware of the switch identifies the model it is on and loads the correct license automatically. I think I have a switch with somet...

nickrezac · 08-07-2014

Unfortunately, I cannot go above 15.0(1)SE3 at all, period. I know about the licensing being fixed, but it is probably an important clue that is why I posted it. At 15.0(1)SE3 and below the switch works fine and I can see that it is showing it is lic...

nickrezac · 08-06-2014

I did, but I didn't try the first one only the second one. the SE1 not the first SE. I can always try that to see if it upgrades the boot loader or something. I did check the requirements and of upgrading to the 15.0(2) series and I was within the mi...

nickrezac · 08-06-2014

The switch does load the 15.0(2)SE6 and comes up to that prompt showing that there is no valid lanbase license. At that point it comes up to a cut version of the IOS it only shows a couple of enable and configuration commands (not the full list). It ...

Member Since	‎08-05-2014 08:24 AM
Date Last Visited	‎09-14-2018 05:50 AM
Posts	5

User Statistics

User Activity

Can't upgrade Catalyst 2960S-48LPS-L to 15.0.2X

This is a fixed switch and

Unfortunately, I cannot go

I did, but I didn't try the

The switch does load the 15.0