I have a 8845 phone with a line that is cfw to voicemail using CUCM 11.5. The MWI for the line does not show unless you take the line off of forward. My 7841 phone will indicate a voicemail while CFW is in place, but not the 8845? Not talking the ...
When a caller is placed into the native queue you do not hear the initial announcement or MOH. The queue works correctly, just don't hear any prompts. This did work during initial setup, but stopped for some reason. Has not been put into productio...
I am running cme 11.5 with 7841 SIP phones. A wireshark capture shows RTP streams going through the CME router and not directly between phones. Is this normal? Should I see RTP chatter between two SIP phones ?
AT
I am running CME 11.5 and need to upgrade to11.6. After the upgrade two issues were observed that made me go back to 11.5. no time to trouble shoot the issue. One issue was the time was off on the phones. Went back to 11.5 and all was fine. The ...
The line does indicate a voicemail as long as it is not forwarded. As soon as you forward the line, the indicator disappears. A 7841 phone does indicate a VM using the same line when it is cfw. It is an issue with the 8800 phones it seems.
AT
Thank you for the info. The two docs kind of contradict each other. My application is CME not CUCM.
This format mentioned:
•16-bit PCM wav file
•Stereo or mono
•Sample rates of 48 kHz, 32 kHz, 16 kHz, or 8 kHz
The voice-bits says only 8K Hz audi...
