hello forum team, we are planning to migrate 913x APs to 916x APs to follow new WPA3 standard and wifi 6, however I do not see option for external athena in new 916x APs. Do You know if this is supported?
hello forum Guys, I would like to discover eigrp neighbor AS system nr to configure eigrp in between 2 routers - is there any debug command I can use to achieve this? I have: top: R1----------R2 R1#sh ip int br
Interface IP-Address OK? Method Sta...
Hello guys,
I have 2xC3850 stadck switches. Now they are working as standalone switches, both in active state when you issue sh switch command:
sh switchSwitch/Stack Mac Address : 9c57.ad9f.4300 - Local Mac AddressMac persistency wait time: Indef...
Hello forum guys,
I have three switches in LAN network which run in rapid-pvst mode. I would like migrate to mst.
I try to search cisco documentation and I found that migration from 802.1D to 802.1w is cousing outage:
http://www.cisco.com/c/en/us...
Hello guys,
I have an issue two C3850 switches. One of C3850 is in the production and operates normally - second one I am adding to the production. Previously those switches were stacked - however I DO NOT want them to stuck. I want them to operate ...
I created packet capture however it does not show anything: access-list 100 permit ip any any
monitor capture buffer CAP-BUF size 2048 max-size 1518 linear
monitor capture buffer CAP-BUF filter access-list 100
monitor capture point ip cef CAP-POINT ...
this is config for R2: router eigrp ???
net 38.1.1.8 0.0.0.0btw - network statement was discovered from multicast ping. we need to find out what is AS of eigrp without looking at R2 - we do not have access to R2. if interface on R2 was passive, we w...
debug eigrp neighbor does not show anything... packet capture yes, but assume that I have only routers to play with. when I configure: router eigrp 2
network 38.1.1.3 0.0.0.0then I get: R1#debug eigrp packets all
*Nov 20 08:37:54.647: EIGRP: Sen...
hi
I have done similar config but I can not reach vrf sites between PE routers:
PE2:
PE2#sh run | s bgprouter bgp 65006 bgp log-neighbor-changes neighbor 172.56.17.7 remote-as 65006 ! address-family vpnv4 neighbor 172.56.17.7 activate neighbor 1...
