Hi, i operate a colo center and i am using a 3550-EMI to aggregate customer switchs. But i need to be able to limit bandwidth in BOTH directions on the switch port. I have managed to get this to work on outgoing but i can't get it to work both ways a...

i would like to use a Cat6509 with (2) Sup1A-MSFC/PFC to route my 2 internet questions. I would like to run BGP and accept full routes. It will also have 6348 48port cards to connect my switches to. I would also like the 6509 to route VLANS. Any Cons...

Hello,I am beginning to put together some idea's on what cisco products i will use for the network. There will be 2 ISP's to start, running BGP. I will be providing managed servers with this network and also unmanaged servers. I was going to get 2 65...

Hello,I need to be able to apply a policer to a single interface on a 3550-SMI limiting all IP inbound and outbound traffic to 1 Meg for a colocation customer.I have tried to configure this several times and i have read every cisco doc on qos. I am s...

Hi, i have a 3640 router and a server that i use to poll for mrtg graphs. What are the commands to setup an ACL or something that can block snmp from everything but that host.