Hello, I am looking to implement 802.1x for our wired ports. I have a working solution. The device connects and successfully authenticates. The VLAN is not set by the radius server but is provided by the switch port configuration (Switch access VLAN ...
Hello,
On the odd occasion our 100meg WAN circuits at our branch offices are getting maxed out and this is causing a few problems with VOIP.
I was thinking about using some QOS to solve this. Is it just a case of adding the below config onto the ...
Hi, I have noticed that our Cisco 2960-X switches have the IP Routing command. I was wondering how good of a layer 3 switch these are please? Does anyone use them as a Layer 3 switch at all please? Thanks
Hi, I was wondering if there is a way using the show mac address-table command to show a list of ports that have more than 2 mac addresses associated with them please? show mac address-table returns many unwanted results and makes it hard to work wit...
Hi, I am a CCNA (Working on the CCNP very soon when I get back from my holidays) so I am not a total idiot, however I haven't worked with Virtual Stacking yet. This configuration wasn't setup by me. We have 2 x Cisco 4500X in a Virtual Stack. When th...
Hello MHM, I added authentication event fail action authorize vlan 506 - It didn't seem to work. I connect a device (standalone laptop) and it doesn't get an IP address from VLAN 506. Connected a domain laptop to this port authenticates and works wel...
Thank you. I will give that a try! Do you know any show commands to view if a port passes or fails authentication please? It will be useful in troubleshooting. I haven’t actually implemented 802.1x on wired ports before. Thanks Again!
Thanks. For a small branch office with a small amount of devices where we would want to separate IP phones into 2 vlans would you use the 2960-X as a L3 switch please? Thanks
