try changing ip nat inside source list 1 interface GigabitEthernet0 toip nat inside source list 1 interface GigabitEthernet0 overload.if still not up after that can you post a sh ip nat translation as well as the sh ip int br previously requestedThe ...
Hi Dylan,Thanks for the clarification on those commands purpose.What type of communication does that Open Table PC need? Looking at the commands for that in your show run it is unclear what you are trying to accomplish. Have you tried any of the f...
Hi Dylan,I am making some notes on your show run. From what I can tell about your network these changes should get your static nat translations up and running. Some of the lines are marked through because they are redundant or not needed based off ...
Hi Dylan,How many IP's are in your IP range you are assigned from your ISP? Are they static? I am working under the assumption that you have 1 static IP address assigned from your ISP. Is that correct?Also is PAT working? Thanks
When the command is at its default state it will not show in the output of show run. Depending on the version you are upgrading from the default behavior may have changed. For example auto-summary had its default behavior changed to disabled in 12....