About AnthonyDunn2010

AnthonyDunn2010 · 10-11-2014

Hi All, need help with nat setup, so my setup is as follows (just on packet tracer), i have 4 routers which can be seen below , R1, R2, R3 and the Gateway 1.1.1.1 which is supposed to be my isp. so will refer to it as ISP.If i ignore R2, and concentr...

AnthonyDunn2010 · 09-16-2014

Hi Guys,Not sure if these forums are meant for noobie questions but i'm new to the cisco / networking side of things. Read a fair few discussions on trunk ports etc and what they are and how they work. and I understand they should be used when commun...

AnthonyDunn2010 · 10-11-2014

Hi Gusy, i managed to get this working creating a nat pool and an access list, then put the ip nat outside on serial2/0 and ip ant inside on the two fast ethernet portsaccess-list was setup to accept all from 10.10.10.0 0.0.0.255and pool was just on ...

AnthonyDunn2010 · 09-17-2014

Thank you for your help Rezamuch appreciatedAnthony

AnthonyDunn2010 · 09-16-2014

Thank you for the reply Reza one last question, "multi-vlan access port"is this something the switch depending on its model will automatically recognize and allow or is this enabled when both data and voice vlans are specified?so how would i know loo...

Member Since	‎09-16-2014 12:49 PM
Date Last Visited	‎08-18-2017 04:02 AM
Posts	5

User Statistics

User Activity

Help with NAT

Help understanding Trunk ports

Hi Gusy, i managed to get

Thank you for your help

Thank you for the reply Reza