About jamesrusso

jamesrusso · 06-13-2019

I have two stacked SG500-52P units. These units were power cycled last night due to our UPS becoming exhausted after an extended power failure. Since coming back up a certain bank of port (7-12, 31-36) have been having POE issue. They will show large...

jamesrusso · 09-19-2014

Hello, I am updating this question because I have reconfigured things. I am attempting to setup two SG500-52P switches in a small office with the following scenario:VLAN 1 - 10.1.0.0/24 - ManagementVLAN 5 - 10.5.0.0/24 - Network Gear (sonicwall TZ21...

jamesrusso · 06-13-2019

@ktonev wrote:Hi James, It sounds like there may be an issue with the PoE delivery on these ports. Can you please open a ticket so we can investigate and let you know the next steps? Please open a service request with us by contacting our frontline n...

jamesrusso · 09-25-2014

Ok, so I think this is working now, here is what I have setup with a default permit policy..Extended IP access list VLAN_50 permit udp any any any bootps ace-priority 10 deny ip 10.50.0.0 0.0.0.255 10.10.0.0 0.0.0.255 ace-priority 20 log-i...

jamesrusso · 09-24-2014

James, Thank you so much for taking the time to set this up in the lab. I think you are likely on the right track and I will try and configure this later this evening and report back my findings. Can someone just explain when the ACLs are actually e...

jamesrusso · 09-24-2014

Tom, Thanks for commenting. I've read lots of your other posts on here. Right now we have the following Port 1 Upstream to Sonic wall on 10.5.0.0/24 subnet. Sonicwall is 10.50.0.1Port 2 and Port 24 ports to Access Points. This has untagged Vlan 1 (mg...

jamesrusso · 09-23-2014

I have done as you suggested, but this will still allow traffic to our internal VLANs on those ports. I need to secure these internal VLANs from traffic originating from VLAN 50. Right now, I can still get to port 80 on 10.30.0.10 which is our PBX..S...

Member Since	‎09-19-2014 08:33 PM
Date Last Visited	‎06-19-2019 12:35 AM
Posts	8

User Statistics

User Activity

SG500-52P POE Ports no longer working after reboot.

Understanding SG500 IP ACLS?

Re: SG500-52P POE Ports no longer working after reboot.

Ok, so I think this is

James, Thank you so much for

Tom, Thanks for commenting. I

I have done as you suggested,