Hello! I ask your advices! I have Cisco 881, which is connected to the Internet. There is a VPN-tunnel on it to a host. command "Ping" from 881 to this host is working. But from the PC behind the cisco is not going. I see the Internet, but not the host. That is my config: version 15.2 ! interface Tunnel0 description --=VPN=-- ip address 10.0.0.11 255.255.255.252 tunnel source FastEthernet4 tunnel mode ipsec ipv4 tunnel destination 123.345.67.89 ! interface FastEthernet0 switchport access vlan 2 no ip address ! interface FastEthernet4 description WAN ip address 184.108.40.206 255.255.255.248 duplex auto speed auto ip nat outside ! interface Vlan2 ip address 192.168.0.3 255.255.255.0 ip nat inside ip virtual-reassembly in ! ip forward-protocol nd ip http server ip http authentication local ip http secure-server ! ip nat inside source list NAT interface FastEthernet4 overload ip route 0.0.0.0 0.0.0.0 220.127.116.11 ip route 192.168.100.0 255.255.255.0 10.0.0.10 ! ip access-list extended NAT permit ip 18.104.22.168 0.0.0.255 any ! Thanks beforehands!
... View more