Hi. We have 2 CUCM cluster connected via SIP trunk. When phone 1 calls phone 2 signalling should go through CUCM’s and RTP from phone 1-MTP-phone 2. On SIP trunk I set up MRGL to use MTP. Should Media Termination Point Required thick box be enabled? ...

Hello. I'm trying to upgrade Prime Provisioning database and application server from 10.6 to 11.0. When I start the upgrade I get error "Order is in progress, could not to the upgrade".  How do I view and delete all active orders so I can do the upgr...

Hello. I'm trying to get some reports for UCM/CME voice call quality reports. I use only CUCM to calculate MOS values (no NAM or 1040 sensor).  But I don't get any values in Assurance. I tried changing dates, MOS values, jitter, etc but never get any...

Hi. I need help with configuration   Call for number 444-444 comes to CUCM1. It is translated into 555-111 and send to CUBE1. CUBE1 and CUCM1 use MGCP. CUCM1 uses CUBE1 as MTP and signals CUCM2 that a call is coming. Call signaling is done via CUBE1 ...

I created synthetic phone in CUCM with MAC 00059A3B7700. Status of the device is Rejected. Before I can run any test I guess I need this device to be added to Prime Assurance. How do I do this? If I try to run the test I get this message "The Cisco ...