Dear Community,I would like to to ask you for a little help or hint regarding the strange issue which I have with the OSPF protocol.Below I will try to explain how the network topology looks like.I have few locations which in most cases have two rout...
Dear Community,
Is it possible to display information on the IP Phone or Jabber about the calling number which called to a user, who has configured "Forward All" feature to the voicemail, but didn't left cany voice message?
In other words, if a user ...
Dear Community,Could you please reccomend which alert messages will be useful in case of 802.1x and MAB authentication and which could be turned on on the Cisco ISE server?I assume that I should serch some with the RADIUS name, but if all are needed ...
Dear All,I'm trying to figure out what licenses are needed to register Cisco AP2802I access points to Catalyst 9800-L Wireless LAN controller. Currently they are registered to 3504 WLC and I would like to migrate them to new pair of 9800-L WLCsI've r...
Hello All,Does anyone can advice if on Firewall Firepower 1010 there is a possibility to configure VLAN interface and under this VLAN interface configure PPPoE connection?I recall that it was possible on the ASA5506-X for example, but I'm not sure if...
Dear Community,It was long time ago when I created this topic, but I'm writing to finally share a solution for my problem.It looks like configration which I implemented was ok, but it turned out that the reson of why OSPF was not working properly was...
Hi Guys,
Ok, so I had a chance to dig into tests and configurations.I can share with you with some results.
So during the weekend I've prepared a lab in GNS3 to create as much as possible the same topology which I ave in production.For the lab topolo...
I've checked HUB1 and HUB2 config and their router-ids are correct.However indeed secondary spoke had this network statement wrong.But I've checked the other location with the same setup. It was ok, but when I was testing it, there was similar proble...
Hi Peter, Hi Guys,I'm sorry for my silence. I'm recently busy with some project.Anyway so far I would like to thank you for all those questions and thoughts, because it's starts to lead me to some conclution which I was suspecting but I was not cople...
Thanks for this checking, however I'm affraid that this lab topology is too simple.The thing is that in my production network this OSPF works somehow partially, which means that some subnets are visible on the multilayer switches, but some not. I had...
