About mohamed Yatim

mohamed Yatim · 10-15-2015

I am currently using a Cisco 2951 router for CME-SRST in my branch office in the event that our MPLS link failed and the CUCM inside our datacenter is unreachable from the branch office.The problem now is that my IP Phones are all able to register t...

mohamed Yatim · 03-21-2015

Please do help to take a look at my attached screenshot.My PC at home is around connected to the RV-130W in my company but I can't seem to be able to ping any of the servers inside my company's network.My home network is 192.168.31.0/24My company net...

mohamed Yatim · 02-24-2015

I need to know how to configure calling party transformation in my CUCM 8.5 In my company scenario, we are currently setting up a whistleblower hotline for both internal and external callers, when all incoming calls from either internal or external c...

mohamed Yatim · 10-19-2015

Ayodeji,How do I configure dial-peers in my 2951 for use only in SRST mode ?I want the dial-peers configured inside my 2951 to stop taking effect once my CUCM is reachable again ? is this even possible at all ?

mohamed Yatim · 03-22-2015

Hi Seito,I am using the GreenBow VPN client version 6.2 nowI have changed the settings to the same as in your screenshot but it is still not working.User authentication is ok and tunnel is open but I still can't ping my router at 192.168.0.1 and my s...

mohamed Yatim · 03-21-2015

Please take a look at the routing table on my home PC.Apparently the GreenBow VPN client added a route of 192.168.0.0 /24 (my office network) to 10.10.10.1 but I didn't configure any 10.10.10.0 network inside my Cisco RV-130W router at all.Can someon...

mohamed Yatim · 02-24-2015

Hi Morais,Many thanks for your prompt solution and help, it is working now but setting Calling Line ID Presentation to Restricted will still show the caller-id for internal callers when they called to ext.888.I have since entered 999 inside the Calli...

mohamed Yatim · 11-02-2014

Hi,I have the exact same problem as described by you. I have assigned a DN to Line 1 on the phone in my CUCM and the phone is still not registering. Can you kindly post the steps that you did to solve this problem ?

Member Since	‎11-02-2014 05:14 PM
Date Last Visited	‎06-11-2018 02:46 AM
Posts	10

User Statistics

User Activity

UC520 as a voice gateway for 2951 CME-SRST

Cisco RV-130W IPsec VPN with GreenBow IPsec VPN client not working.

How to configure calling party transformation in CUCM 8.5 ?

Ayodeji,How do I configure

Hi Seito,I am using the

Please take a look at the

Hi Morais, Many thanks for

Hi,I have the exact same