Have created two point to point L2VPN tunnels between ASR 9k & ASR 1K-X
One tunnel is working fine.
Other tunnel is not working.
It shows up on both the router.
Same configuration is done for both the tunnels.
Please help...
Hi,M using cisco SG300 switches with firmware version of 1.4.0.88.CNA version 6.1have created a cluster admin on cisco L3 3750 but m not able to add any sg300 switches..
I tried configuring snmp string on aironet 3602E. It gets configured but movement i restart the AP, configurations are not saved. I tried using write memory command but no use.Kindly assist
Hi Giuseppe,
Yes i agree with you..its an unusual issue..since VC111 is working without any issue..
ASR 9k are in cluster mode.
How to check ARP tables at system level?
Regards
Gaurish