the end customer wants to migrate the network from IPv4 to IPv6, I know that CUCM can be configured with dual stack, but we can configure the DNS servers with IPv6 on CUCM??? I mean can I input an IP addr V6 with this command:
My CU is near to change their Telco Service provider from E1 R2 to ISDN, they have this card VWIC3-4MFT-T1/E1, so with these one, ISDN Euro is supported or another cards are needed????
I have this output in show license detail cme-srst show license detail cme-srstFeature: cme-srst Period left: 8 weeks 3 daysIndex: 1 Feature: cme-srst Version: 1.0License Type: EvalRightToUseLicense State: Active, In UseEvaluation total period: 8 wee...
I have to get customized historical reports, whe I copy wich I try to copy one for customize, the menu appears like disable to select any item, and I can´t to create new one, so I have to need special rights to create an historical reports and send i...
Hi dgoodmundson1
yes you are right I try to generate a specific report, this is take one report on specific, save it on another location, other than STOCK, configure it to send the output to an email address.
Hi Deepak,
you are right, I am log in with a user that doesnot application user, it is a reporting user, so I need to log in with application user and try it again.
thaks for your support.
Hi Shashank
The c20 has 4.X firmware version, I configure the device on CUCM, the CUCM hasn´t auto-registration, I configure provison to registrer on CUCM.
I follow this doc:
http://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/codec-c-...
