About MinPinsRock-1

MinPinsRock-1 · 09-15-2019

I recently updated the firmware on my SG300-10MP POE switch to version 1.4.10.06 (file name sx300_fw-14106.ros), it is installed in the active and backup file locations. The switch seemed to be functioning perfectly with this firmware, no issues. It ...

MinPinsRock-1 · 09-11-2016

I am trying to upgrade my SG300-10MP to FW=1.4.5.02 but each time I get a "Copy Failed" message. I have attempted using both HTTP and TFTP with the same results. The exact error message is: "Upgrade/Backup Firmware/Language Bytes Transferred: 7273984...

MinPinsRock-1 · 11-14-2014

I own a Cisco SG300-10MP which is in my home office, the FW had not been upgraded for quite some time. The "PID VID" shown on the label on the back of the switch is "SRW2008MP-K9 V01". On the System Summary page it displays "PID VID: SRW2008MP-K9 V30...

MinPinsRock-1 · 09-15-2019

"System LED—(Green) Lights steady when the switch is powered on, andflashes when booting, performing self tests, and acquiring an IP address. Ifthe LED flashes Amber, the switch has detected a hardware failure." My router was not seeing it and was no...

MinPinsRock-1 · 09-11-2016

Solved. I had to go back and download an older FW version and first update the Boot Version via TFTP to 1.3.5.06, only then would it accept the new FW. Rebooted and now everything is fine. Now FW = 1.4.5.02 and Boot Version = 1.3.5.06

MinPinsRock-1 · 11-17-2014

Thank you Aleksandra!

Member Since	‎11-14-2014 06:37 PM
Date Last Visited	‎09-18-2019 01:01 AM
Posts	6

User Statistics

User Activity

SG300-10MP stuck in boot mode (system LED flashing green)

SG-300-10MP sx300_fw-14502.ros COPY FAIL

SG300-10MP FW 1.4.0.88 Error

Re: SG300-10MP stuck in boot mode (system LED flashing green)

Solved.

Thank you Aleksandra!