I have a cucm 10.5 installed, working fine, with two DX80 registered.
We passed from signed certificates to self-signed certificates. The first DX80 registered and the second too.
We can not say how, but the second one unregistered from the...
I have a huge deal:
My client has three cucm: one pub and one sub and one preprod
We did turn the preprod into mixed-mode by the command line utils ctl set-cluster mixed-mode
So we did tje same configuration to the cucm PUB, but th...
Hello, I am new on this system, and I have a little problem about a firmware activation I tried a lot of command lines but nothing happenedThis is the message: Could anyone help me on this? Thank you Regards
Hello, I have a little problem on my SX20 TC7.3.1 with my ISDN Link IL1.1.3. This is the error message i have: Not Sip-Registred to H320 Peripheral. Someone told me it was probably because the SX 20 is in Gatekeeper instead of "direct" and probably S...
thank you! yes it was because of one of these bugs!
I had disabled these services on the sub: callmanager and to be sure, tftp and ctl provider
Then I entered the command utils ctl set-cluster mixed-mode in the PUB and it worked!
I go ...
thank you for your answer, i did not execute this command on the sub, at least i could not.
"this CLI is only applicable for PUB"
The cluster security mode for the PUB is at "0" and LBM Security Mode to "Insecure"
Hi, Ok, now that's ok, i mapped a virtual device to a dvd driver on my computer, it worked, I made the updates. But i still have the error I don't know why because i made the whole update.. Can anyone help me on that? Thank you
Hi Brandon, I did a bootable usb drive, plugged to my computer and mapping via KVMBut now the issue is: I tried different method of creating a bootable usb drive..I saw this page from cisco https://communities.cisco.com/docs/DOC-56147 but we don't h...