Hi, I have a working instalation of CUCM 8.0(3a)SU3 and I wish to upgrade to 8.6 (latest version 8.6(2a)). Do I need new licenses or this upgrade is free of charge?Thanks in advance!Best regards,Konstantin
Hi All, We recently had HW problem on our Publisher. After that we had to replace the HDD of the publisher node and now we have to do Restore from backup. We installed a fresh copy of CUCM 7.0.2 and tried to restore the backup "offline" (connected on...
I'm trying to do Object NAT in 8.4.2 for a mail server and I'm now seeing that the rule is working only from outside->inside. Whenever the mail server sends a message it is translated with the default Dynamic NAT defined in the rules. I cannot unders...
I've configured SRST fallback and everything is working fine (the phones register, dial each other, outgoing calls work) except the incoming calls.The extensions are 3 digit. Full number 2124XX, extensions 4XX.The incoming calls dialed number is 24XX...
Hi all,I'm working on a CUCM 8 installation with mainly 6921 IP phones. We are using SCCP protocol in this installation but unfortunately these phones do not support SCCP SRST on any version of software.Is it possible to configure a SIP SRST and to u...
Hi, I'm doning the same upgrade on the SM. I tried the archive download-sw command on the 3750X itself but after the image is downloaded I get the error "ERROR: Image is not a valid IOS image archive.". Should I run this command on the module? If yes...
Hi, I already have downloaded the upgrade media from the Download Center. The question is whether I would need new licenses for 8.6 or the current licenses will work with the new version also?Best regards, Konstantin
Hi aokanlawon, The versions of the CUCM are completely the same (the one that you specified). Also we are using completely same hardware, only the HDD is changed with a new one. The hardware is MCS 7816-I3.Best regards, Konstantin
Hi Gordon, We just tried a restore on a fleshly installed CUCM server and it failed again. Just to clarify, we connected the server in the live environment with no configuration done except the basic things requested in installation. We haven't done ...
One more question, do we need to configure the parameters on the newly installed server fof both of the nodes in: System -> Server, System -> Cisco Unified CM and System -> Cisco Unified CM Group? In other words do we need to configure the Cluster on...
