Hi,Please explain me this error : SNMP-3-INPUT_QFULL_ERR: Packet dropped due to input queue fullI want to know a)What causes this error.b)Is this snmp or something with the switch.c)Any MIB related to this error.d)What's the solution.I know warm rest...
Hi,I just want to clarify that I've read snmp is a low priority process. So does this means in case of high cpu any other process is going to take cpu utilization and snmp polling is going to stop? If not then what's gonna happen to polling and does ...
9800 appliance does not require a trustpoint. Wireless management trustpoint is required only for virtual WLC deployment. You can remove the trustpoint by using "no wireless management trustpoint" command in config mode
9800(config)#no wireless man...
8.5.164.0 is for the IRCM deployment. As per the TAC recommended AireOS document, this image is not supported for other platforms, nor is it supported for non-IRCM deployments. The CSCvq55777 is fixed in 8.5.161.x escalation image. If you are not run...
John,
Try to use static IP address on the AP as Leo mentioned earlier. The command is "capwap ap ip address A.B.C.D" and "capwap ap controller ip address 172.16.10.5" from AP CLI.
Is there any firewall between AP and WLC blocking UDP 5246 port ?
John,
From the shared logs the config looks okay. The SN confirms that you are not running into CSCuq19142 which is common in old APs. Although 2 APs will soon hit the cert expiration. For more information see:https://supportforums.cisco.com/document...
