I have used the SG300 numerous times in layer 3 mode to route between vlans with no problem. This SG350X however is totally new and I can not make it work. Each port can be set individually to layer 2 or 3 instead of the entire switch.  Any port set ...

With the SG300 series switches you choose layer 2 or 3 mode for the entire switch in the Administration section. The SG350 does not have that setting. It has a 2 or 3 on each and every port. To get the same effect as before do I need to change each p...

Setup:                                   192.168.1.23ASA5505    ------------     SG300-1    ------------   SG300-2    192.168.1.21192.168.1.1                          |                                            +---------------------   SG300-3    19...

Where can I find simple instructions on getting this to work? It seems so straight forward and yet it refuses to work. What I've tried:1. Added a new Vlan (5) and assigned it 10.0.0.12. Added a new Zone and assigned it to the new Vlan and assigned it...

I need to add some rules to block some attacks. I can add them fine but they get added to the end of the list. I try to re-order the rules to put them at the top and can not. I am using Internet Exploder 8 and I put a checkmark on the rule I want to ...