About Ahmed Muhi

Ahmed Muhi · 05-31-2017

Hi All, I hope you all are doing great. I am facing a problem with MACsec technology, below are the details of my setup: 1- I am using ASR 9010 on one side and ASR9910 on the other side. 2- I am using "A99-12x100GE-CM" and "A9K-8X100GE-L-SE" Line ...

Ahmed Muhi · 05-03-2017

Hello All, Is the A9K-8X100GE-CM Line Card Supported on RSP440 or RSP880? I could not find anything about it online, below are the Data Sheet for RSP440 and RSP880 and there is no mention of the A9K-8X100GE-CM Line Card. http://www.cisco.com/c/en/us/...

Ahmed Muhi · 02-17-2017

Hello All, This is a follow-up discussion to a previous one that I have opened previously, I have an NCS5002 acting as a Satellite, and two ASRs 9006/9910 acting as Hosts using IOS-XR 6.1.2, in an Active/Standby nV Satellite scenario. below are the ...

Ahmed Muhi · 02-15-2017

Hello All, I have the following scenario, I have an ASR9006 and ASR9910 acting as Hosts, and an NCS5002 acting as Satellite, all devices are running IOS-XR 6.1.2, below is the config I am using and some of the show commands for your kind reference, ...

Ahmed Muhi · 12-19-2016

Hello All, I was trying to upgrade the NCS 5002 from IOS-XR 6.0.1 to IOS-XR 6.1.2, during the upgrade I received the below log message, still the upgrade was successful, RP/0/RP0/CPU0:Dec 19 11:47:57.098 : resmon[358]: %HA-HA_WD-4-DISK_WARN : A mo...

Ahmed Muhi · 06-02-2017

Hi Vincent, Thank you so much for your kind support and reply, highly appreciated. Kind regards, Ahmed Muhi

Ahmed Muhi · 05-03-2017

Hello Eddi, Thank you so much for your kind and prompt support, it is highly appreciated. Kind regards, Ahmed Muhi

Ahmed Muhi · 03-05-2017

Hello Xander, Thank you so much for your kind reply, I have removed the configuration and re-created the scenario from scratch, and now it is working. I have collected the below results, maybe preemption was introduced in IOS-XR 6.1.2 . I have simu...

Ahmed Muhi · 02-17-2017

Hello Aleksander, Thank you for your kind support, I swapped the ICL cables before and the problem follows the Host port. Fortunately, I was able to find out what my problem was, I had used the same devices earlier to test the MC-LAG technology, the...

Ahmed Muhi · 01-07-2017

Hello Aleksandar, That was an interesting tool, thank you for sharing.

Member Since	‎09-02-2011 09:33 AM
Date Last Visited	‎07-04-2018 12:05 AM
Posts	43
Total Helpful Votes Received	95

User Statistics

User Activity

MACsec on ASR9010/ASR9910 with IOS-XR 6.1.3 not working

Is the A9K-8X100GE-CM Line Card Supported on RSP440 or RSP880?

Does the nV Satellite Dual Host/Home support preemption?

nV Satellite Dual Host/Home unable to switch to standby host

How to free up space in NCS5002, received A monitored device / is above 80% utilization during upgrade

Hi Vincent,

Hello Eddi,

Hello Xander,

Hello Aleksander,

Hello Aleksandar,