DX80 with CE8.3.1 firmware registered to CUCM 10.5.2: When the DX80 is in a virtual videokonferance where content is beeing shared. the DX80 snaps back to PC mode and the user has to click on the "hide PC" button to switch back. This seem to happen i...
In Prime Collaboration Deployment, install guide, says PCD requires that you use a DNS server. However in the Release Notes it states: "If you require DNS on a PCD system, be sure to administer the DNS during PCD install". If there is no DNS for the...
I have a issue where hunting between POTS dial peers (FXS port) does not work. The Dial Peers has the same destination Pattern configured (4010).The wanted behaviour is for the call to hunt to the next dial peer when there is no answer. I know that i...
Depending on what FXS port makes the call, how can I prefix the called party number in order to route the call as described below?:FXS port 1 should be prefixed with a digit(s) so it can be routed to Location B, PSTN breakout or to a phone on this lo...
How can I configure the cisco router/gateway thats connected with a PRI to a legacy PBX to discard any invalid Calling Party Number on calls coming from the PBX (a number not in the valid configured range on the legacy PBX?Toplogy: Legacy PBX--PRI--C...
@Maren MahoneyI found the solution to my problem described above. The trick is to open the CSV file in the un-tar'ed file with NOTEPAD++. At least this works for me. Notepad ++ opens the CSV file directly in an Excel style "editable format", and not ...
@Maren Mahoney Thank you Maren for your reply and suggestion. I did what you suggested, but unfortunately the result is exactly the same. BUT, I see in your video when you double click the phone.csv file, it opens directly opens up in Excel so you ca...
@Maren Mahoney I am having trouble with the Export/Import. I am on CUCM 12.5.1.11900-146. At the Import the Job Scheduer log gives the error that the first field in the csv file is not a supported field: "services provisioning is not a supported fie...
Jonathan, how would you do the import again? Its not possible to to a import via Bulk Administration-->Import-->Import, as you need to have done a Export from here to get the headers that is needed for the import.What is the recommended way of bulk u...
I have the same issue; the built in account (CUCMAdmin). I read that the default policy is 30 min to wait before you can try again (after 5 times with the wrong password). However after the 30 min I am still not able to log in. Can I perhaps reset th...
