Dears,
We have Cisco CUCM 11.5 installed with 100 Cisco phones in addition to Cisco Voice Gateway with PVDM3.
Now we need to deploy Cisco Jabber for IM and Video conference.
What is the licenses that we should add and how many Jabber users that...
Dears,
I have a CUCM with VG, now I need to register (2x DX80, and EX60) to my CUCM.
Please advice if I can do a conference for the three endpoints together without using MCU, is this applicable or I need to add a MCU?
Regards,
Hi,
I used this pattern 9.XXXX and it is work fine. But when I trying to 91.XXXX it is not worked.
Anyone can advise how I can use two digits before the dot? I need to press 91 then I will get tone after that I need to enter my DN and the 91 will be ...
Dears,I have core 6506 with POE Ethernet module. I connected cisco Access points and telephone devices and it was supply them power normally.Now the Ethernet module stop to supply the POE for these devices and I got the below messages:- The device co...
Dears,I have CUCM 9.1.2 I deleted phone and when I tried to add the same phone I got this message (Add failed. Already exist in the data base).Any suggestions please
Thank you Jaime
As understood that we have to buy the below items in order to initiate the video Conference for Cisco Jabber:-
- (CTI-CMS-1K-BUN-K9) Cisco Meeting Server 1000 Bundle
- (TP-SMP-K9) Cisco TelePresence Shared Multiparty
- (L-TMS-25) ...
Hi,
I have PVDM3-16 installed on my VG which will be enough for 1 conference with 6 participants and we have to configure video conferencing on my CUCM.
Hi Manish,
Thank you for your reply, I already talked to Cisco support, they confirm me that no need to add MCU as I already have CUCM and Voice Gateway router, so no need to add MCU the Gateway will handle the conferencing for the 3 endpoints.
ok, Is there any specific configuration, because when I configured it I got the outside dial tone once click on 9 as the cucm doesn't wait for the next digit (1).
Please advise,