Ali Bahnam
Level 1
Level 1
Member since ‎05-27-2012
‎01-31-2021

User Statistics

  • 183 Posts
  • 2 Solutions
  • 5 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
1 Accepted Solution
1 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies
Certifications

User Activity

Dears,   We have Cisco CUCM 11.5 installed with 100 Cisco phones in addition to Cisco Voice Gateway with PVDM3.   Now we need to deploy Cisco Jabber for IM and Video conference.   What is the licenses that we should add and how many Jabber users that...
Dears, I have a CUCM with VG, now I need to register (2x DX80, and EX60) to my CUCM. Please advice if I can do a conference for the three endpoints together without using MCU, is this applicable or I need to add a MCU? Regards,
Hi, I used this pattern 9.XXXX and it is work fine. But when I trying to 91.XXXX it is not worked. Anyone can advise how I can use two digits before the dot? I need to press 91 then I will get tone after that I need to enter my DN and the 91 will be ...
Dears,I have core 6506 with POE Ethernet module. I connected cisco Access points and telephone devices and it was supply them power normally.Now the Ethernet module stop to supply the POE for these devices and I got the below messages:- The device co...
Dears,I have CUCM 9.1.2 I deleted phone and when I tried to add the same phone I got this message (Add failed. Already exist in the data base).Any suggestions please
Community Statistics
Member Since ‎05-27-2012 02:56 PM
Date Last Visited ‎01-31-2021 10:40 AM
Posts 183
Total Helpful Votes Received 5
Helpful Votes From
Helpful Votes Given To