About fragilemahinder

fragilemahinder · 02-17-2013

Hi I have 2811 router with VWIC2-1MFT T1/E1 ... i have done the desired config on 2811 and tested the card Layer1 connectivity using Loopback tester..same Loopback L1 testing i did with NEC aspire PBX .. got success..But i don't know for some reaso...

fragilemahinder · 06-24-2013

Hi,By default XR IOS ie ASR 9K filter EBGP route incoming , have you created Pass route-policy to allow route in to VRF ..if you can post your config i might can help youregardsMahinder

fragilemahinder · 06-24-2013

Hi,Check below if that helps you ..http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/layer2/513_n1_1/b_Cisco_n5k_layer2_config_gd_rel_513_N1_1_chapter_0110.html

fragilemahinder · 06-24-2013

Hi,Peer-switch will make both N7K-1 and N7K-2 as Root Bridge , and why do we need to make both N7K as root is here goes..Suppose primary Switch N7K-1 fails which is Root bridge in that case secondary vPC switch N7k-2 will elect itself as Operation...

fragilemahinder · 02-19-2013

Hi,thanks I have sorted out the actually NEC aspire said it was a E1 card but later during my testing i found it is PRI card so i change my config and started working ..

fragilemahinder · 02-17-2013

Hi,You can use VRF aware tunnel all the way from one PE to another PE .. and in PE a default route or static vrf Aware route entry like " ip route vrf A and default or static route entiries in CE also to forawad traffic to PE ..this will tranpare...

Member Since	‎02-14-2013 10:21 PM
Date Last Visited	‎09-14-2018 12:37 AM
Posts	7
Total Helpful Votes Received	10

User Statistics

User Activity

NEC Aspire PBX Integration

IOS-XR - Route Leaking between VRFs

Ip phone and 2248 fex.

Turning on peer-switch in production vPC setup

NEC Aspire PBX Integration

Re: VRF,LDP and MPLS