When we upgraded our 5K's recently we experienced an issue where the port-profile inheritance was removed and replaced by the port-profile commands minus the VPC ORPAN-PORT SUSPEND command which was also removed from the port-profile configuration. T...
We are trying to upgrade from 8.2 to 8.3 (or beyond) and want to know if with the changes to NAT do we need to convert all of our NAT rules for access from the DMZ to the internal network. We have some static NAT statements for both single IP's and s...
Recently we installed a pair of Nexus 7010's and we recently moved them to an APC rack better suited for their size. Upon powering them up we found out that the VDC's lost their configurations. The VDC's and the alloated resources were still there as...
I want to limit an anolog phone connected to an FXS port to dialing internal extensions and 911 only. What is the best way to go about this?Thanks,Eric McManamyNetwork Techonology Solutions
Great answer however I seem to have a problem with that command within the vlan configuration. I do have the Layer 3 modules installed but they are not being used because we needed IOS features on SVI's NX-OS couldn't do.Is there a feature I need to ...
Just incase any one is still interested, I have been fighting this same battle with Nexus 5596's and the B22HP FEX and have found the same results.Also, here is the most recent configuration guide (5.x) that confirms Bruce's findings in the 4.x code....
Thank you for replying and my apologies for the vauge question. In most of the firewal confirurations I have seen or examples Cisco has provided, there has always been a NAT statement like the one listed below.static (inside,DMZ) 172.16.34.0 172.16.3...
Thank you for the reply. The system we are using will be a 7750 with an MRP3-8FXS and another MRP3 running the Multi-flex cards. Would I still be able to use the solution you suggested?Thanks,Eric McManamy