About Timothy Burns

Timothy Burns · 07-12-2018

Just had a quick design question to get further insight on. We have small enterprise campus with about 80+ switches. Currently we setup vlans per closet that are trunked back to the core and have vrf's per function and route between VRF's. Examp...

Timothy Burns · 06-26-2017

I went to install a 7811 and found out that this was not a supported device. However we have other 78xx(7821,7841,7861) phones in our 9.1 call manager environment. Do I really need to install a device pack just for this one phone? Could I just insta...

Timothy Burns · 04-22-2016

Our marketing department has decided to begin inserting messages for upcoming events onto the default on hold music and has started wanting this changed every week. As far as I can tell this is a manual process to change the .wav file that is used. ...

Timothy Burns · 10-29-2014

below is my config that i am testing with.ip access-list extended testdeny ip host 192.168.72.2 192.168.25.0.0 0.0.0.255permit ip host 192.168.72.2 anyint vlan 10ip address 192.168.72.254 255.255.255.0ip policy route-map 857route-map 857match ip addr...

Timothy Burns · 01-28-2014

Switches: 3560routers: 2811AP: 1552eWe have 4 1552 AP's that we would like to setup in a point to point environment. Currently they are light weight but we would make them autonomous for this scenario, unless there is a feature in the controller that...

Timothy Burns · 10-18-2017

I am currently running 5520's running 8.4.100 code. Up to this point I have seen no reference about this version. Has Cisco abandoned this? Our plan is to get to 8.5 fixed release when it comes out. I just thought it was odd that I haven't seen any...

Timothy Burns · 07-06-2017

JB, Thanks for the follow up. I mean to ask that design question. This was setup before I started at this location, so I am not sure as to why this was configured this way. But, I will plan to make this design change. Thanks again for the advice.

Timothy Burns · 07-05-2017

JB, Thanks again for you assistance. I proceeded as discussed and the install went well with very minimal downtime if any. The primary for our phones is the PUB. As a test, I created an ACL for my phone blocking access to the PUB and was able to se...

Timothy Burns · 07-03-2017

JB, Yes this helped. One answer I have not been to clear on is actual downtime. My assumption is that following the steps users should not experience any downtime. Is my assumption correct? - install file on both pub/sub - go to software defaults an...

Timothy Burns · 06-27-2017

Thanks for the reply an confirmation. Just to have an idea, what kind of downtime should I be expecting assuming I put back the firmware versions for the phones so that they do not need to restart? Thanks

Member Since	‎03-13-2012 07:43 AM
Date Last Visited	‎09-07-2018 12:03 AM
Posts	25

User Statistics

User Activity

campus wide vlan

CUCM 9.1 device pack question

Changing on hold music in Unity

Policy Based Routing 6509

Using 2 1552 bridges for high availability

Re: Cisco plans for tackling krack attacks

JB,

JB,

JB,

Thanks for the reply an