Hello,
Just found something odd.
Custom profile for a few printers.
I then added them to a logical profile.
Created a policy for them.
Tested the printers, they get the profiled.
They show up on the logical profile, I can see all MAC addresses...
Hi,I was looking for design recommendations for a particular design scenario.I am working on an E/W FW with IPS and I am looking for a recommendation on how to setup the IPS Variable set - $HOME_NET. I have about 50 Interfaces and 90% of the traffic ...
Hi Everyone,
Simple question, how many user agents can I connect on FMC? I know I can have multiple agents configured, but how many is the limit?
Are they all active at the same time or it works as active/backup?
Hi Marvin,
CSCwe44571 says the problem is fixed on 7.2.5.1. I had the issue and I had TAC on the line, we managed to save some disk space with the same commands + deleting some old PCAP files.
NOTE: I upgraded the FMCv to 7.2.5.1 and I still have i...
You are not just changing the FMC or FTD management IP address, you are deploying a new FMC and you need to move the FTD to this new FMC.
As per today, I am not aware of a "simple method". Here is what I have done in the past: (assuming you're doing...
One last update.If you need to change the management IP address from the FMC, but you dont want to lose the configuration on the FTD you need to visit the FMC and go to the FTD device page and disable management of it. Then go to the FTD device and c...
To avoid any possible problems Cisco recommends you to deploy using version 6.2.3. The version with problem 6.2.5 was removed from the AMP console, and if you already downloaded it you should not use it.