Hi Experts,We have been facing issues with the Error (%DOT1X_SWITCH-5-ERR_ADDING_ADDRESS), after enabling 802.1x on switch 3550 , After working on the Error we have found in blogs to do the following.ResolutionReference Link: https://supportforums....
Hi Experts,Can we achive this :1. We have Two 3900 Router on the core layer which are terminated with one ISP on one Router and Secondary ISP on Second Router.2. Can we configure my ASA 5520 with Active/Standby termenating two IPS ...
Hi Experts,I am new to ISE, Please help me out.Please find the attached scenario of my Query.Scenario:Due to scarcity of LAN ports in our Office Conference room we have placed an Un-managed switch and plugged the Un-Managed switch port to one of the ...
Hi Experts,I am new to Cisco ACS, Can anyone recommend me a good reference book and helpful links which will help me to configure ACS 5.x .Thanks In AdvanceKiran Kumar CH
Hi Guys,I am faced with the challenge of connecting 2 core switches located at different building about 2 Km distance from to each other. I choose to have on one end, the core switch WS-C3750-24TS-E and the other end with same core switch WS-C375...
Hi Alex,Firstly i want to thanks you for your reply, We will follow the same once we get the same Error once again and will update you if we have any Issues.Thanks and RegardsKiran Kumar CH
Hi,I would like to use 2 ASA in Active/Standby Mode, and like to route Traffic via Secondary ASA when Primary ASA or ISP Goes Down.Thanks and RehardsKiran Kumar CH
Hi As you have mentioned that "That's not the only solution" is ther any other configuration from which we can achive to route all traffic via Secondary ASA when Primary ASA or Primary ISP Goes Down other then BGP, If so could you please help with r...
