Upgrading VMware vSphere ESXi from 5.5 to 6.7Wondering is Telepresence Conductor XC4.2 will function.cisco.com Virtualization page says XC4.3 supported with ESXi 6.5 no mention about ESXi 6.7In short, will Telepresence Conductor at xc4.2 or 4.3 funct...
Need to configure a ISR G4 4331 device with a T1 PRI Interface..The interface must supply clock to a legacy PBX...Old command in the 28XX/38XX-29XX/39XX under controller was "clock source internal"
Ill be emulating the NETWORK side in this configurat...
Upgraded from CUCM 8.6.2 to 10.5.2Now using CDR Analysis and Reporting in 10.5.2, I can not select the Local TimeZone.The pull down only shows UTC and GMT...In version 8.6.2 the pull down shows my LocalTimezoneAm i missing something?
When attempting to export devices(either all or using filter) I'm prompted for a file password, create file PW, then whether I OPEN, save, or save as, I'm unable to use open the file...I get an error message "'Error 0x80004005: Unspecifi...
Mine was a T1, but should'nt make a difference i suspect
card type t1 X X !isdn switch-type primary-ni
!controller T1 0/X/0 ## Only for PRI to PBX interface framing esf clock source network linecode b8zs pri-group timeslots 1-24!!interface Serial0/X/...
