Hey everyone,I am trying to order an additional inbound/outbound voice E1 PRI (probably R2) to act as a hot standby if the existing E1 fails. Telmex claims they can provide the additional circuit, but a manual failover would be required for the seco...
We use a 2821 and an ISDN E1 in our Panama office. Calls made to international numbers fail during setup. Not all calls fail. Seems that all calls to the US are ok, 50% of calls to Latin American countries fail, and 100% calls to the Carribean fai...
Hi, I have a CUCME7 (12.4(20T)) customer with 7941-G phones that currently load from firmware version SCCP41.8-0-4SR3AS. After upgrading to firware version SCCP41.8-3-3S, the phone will crash, usually just after processing a call. Is it possible th...
I had this issue with a NIM-4FXSP card. I was also getting a thermal error alarm, and the router would shutdown the FXS port. This was a telephone wiring issue. Dial tone was coming from another source and the FXS card did not like it. Once the w...
Unfortunately the command "no failover active" does not work in later versions of code, when the Primary is the only firewall. The command is rejected b/c there is no Standby firewall in the Ready state.
ciscoasa# no failover active WARNING: NO St...
Not using ACS, its all ISE/RADIUS now in this enviroment, but the dACL was originally imported from ACS. The dACL that ISE pushes to the ASA for the VPN session needs to use subnet mask format instead of wildcard format for dACL lines that reference ...
I had this issue also with an 8851 running sip88xx.11-7-1-17. In the CM, the custom phone button template was setup for 5 lines and 5 DN's were configured for the phone. But when looking at the phone itself, I could see the Bluetooth line was on li...
