Hi Siva,If you use the below command then that can be achieved.clock source line independent Please see below for reference:http://www.cisco.com/c/en/us/support/docs/routers/3600-series-multiservice-platforms/8106-vwicmf-t1.html ThanksDJ**Please rat...
Hi Siva, There wil be slip and error seconds on the setup as the backplane can only take clock from one of the line (source) at a time. This will lead to sync issues.There is no alternate way for this and also slip errors may lead to problems like au...
Hi, This will cause problems for sure as we cannot take clock from 2 sources on the same T1/E1 card.It will certainly lead on slip and error seconds on the router. ThanksDJ **Please rate useful posts**
Hi Shameer,Please make the changes as Sreekanth mentioned and if nothing works please share the running config along with the debugs as mentioned earlier.--Divjot Nanda **Please rate useful posts**
Hi Kevin,I see that the call went through port 0/0/2 this time.Have we changed the configuration in all ports.If no then I will ask you to change it in all ports and then try a call. If you have already changed and still the calls are not working, th...