About rolhas1983

rolhas1983 · 06-26-2013

Hi,Is there any debug command that can show me the speed and duplex negotiation on a Cisco Switch port?Best Regards,Rolhas

rolhas1983 · 12-06-2007

Hi,My network scenario is a CallManager 5 connected by a bri interface with a Cisco 2811, IOS Version 12.4(9)T6, to a PBX.When I make a call from the PBX side to the VoIP side i get the "From Unknown Number" message on the voip Phones (Cisco IP Phon...

rolhas1983 · 12-05-2007

Hi,I am having some issues on how to work with authorization levels. I used the Forced Authorization Codes but i do not know how to associate them to a specific user in a scenario where only this user would be permited to make internacional calls for...

rolhas1983 · 12-06-2007

Hi,Here is the debug, for you to analyze.It sends the nember it has dialed, but I don't see any info about it's own number. I dialed 309 on the pbx side, this is what I get in the debug:Dec 6 13:54:36.965: ISDN BR0/0/0 Q931: RX <- SETUP pd = 8 call...

rolhas1983 · 12-05-2007

Hi, Thanks for your help. I was associating the partition to the directory number of the users device... not associating the CSS to the device itself :)Best Regards,Ricardo Rolhas

Member Since	‎12-05-2007 08:11 AM
Date Last Visited	‎07-11-2018 12:38 AM
Posts	5

User Statistics

User Activity

Port autonegotiation debug

Message From Unknown Number

How to associate Authorization level to an user?

Re: Message From Unknown Number

Re: How to associate Authorization level to an user?