About johnmdolan

johnmdolan · 08-08-2017

I have access points that I prepped at my office. They are 2802i. I am replacing 3602 access points and using 7500 flex controllers with 8.2.130.0 software. When I replace them at buildings, they do not show up in Prime. The old ones are still the...

johnmdolan · 05-14-2014

We have 2 5508's, 2 7500's, and 12 4400 series pan controllers. All but one is getting flooded with radius failed to respond. We have three radius server configured for AD authentication. One for BYOD, one for machine authentication and one for gr...

johnmdolan · 05-14-2010

What are people using for a client in windows 7? I have a client for my Intel cards but the Broadcom ones has extensions and the instruction are to set it up through the windows built in client. I don't want to use the built in one.

johnmdolan · 04-07-2008

We are a school system and have clients that do not run machine policies. We are using the utility for the wireless cards (intel and Broadcom)We are using 440 lan controllers, wcs ver 4.2 and 1131 ap's. We also have carts of laptops with autonomous...

johnmdolan · 08-09-2017

I created a new VM with 3.2 and upgraded the controllers to 8.2.151.0. They show up now from one controller but not the other. This may be due to not moving the licenses yet. I dread the license part because it seems Cisco sucks at it. I love the...

johnmdolan · 01-05-2016

I have a Fluke tablet analyzer but its overkill and 50,000. I dont like lugging it around a building to check basics. I bought a Fluke Aircheck, I do 90% of my troubleshooting and testing with it and its a small handheld device. I think it was 1500...

johnmdolan · 09-03-2015

Did you get this resolved? I have the same problem on a 7500 flex controller.

johnmdolan · 05-17-2010

I don't want to use the windows client because if you run that setup wizard, the wpa2 key is in plain text on the flash drive. If you don't use the wizard, the clients have to be configured manually. I use the third party client on all other machin...

johnmdolan · 10-15-2008

It works much better if you use a real client for the card. We went from using windows client to the broadcom and intel clients and it fixed all those issues.

Member Since	‎04-24-2007 12:47 PM
Date Last Visited	‎11-24-2021 10:50 AM
Posts	11

User Statistics

User Activity

Access points not showing in Prime 3.1

Radius response failure

Windows 7 Wireless Client

Group policies from a Domain

I created a new VM with 3.2

I have a Fluke tablet

Did you get this resolved? I

Re: Windows 7 Wireless Client

Re: Wireless Client Domain authentication problem