Hi,
My requirement is to have the same SIP trunk to do both audio calls from the gateway to WebEx through VCS and video calls from the telepresence room to WebEx again using the same route through VCS. The call flow is starting from the call manage...
I have TANDBERG Codec C60 which is having issues connecting to WebEx CMR. The codec is running TC5.1.3.292001 and is registered on VCSC version X8.7.2. The call goes through and the audio part connects fine when connected to the CMR without video. I ...
Hi,I have currently deployed Cisco Jabber along with Expressway C and E for external regeneration without VPN. I have successfully registered IM and Presence service externally on the internet and I am able to chat with other Jabber users. I am not a...
Hi,I have recently deployed Cisco Presence Server and integrated with Call Manager 9.1.2. I have successfully deplyed 6700 users on IM & Presence. Some of the users requested for Cisco Jabber with phone control.I have added CFS client on the Call Man...
Hi, I am unable to install CUCM 9.1.2 as a subscriber node on third party approved server - IBM x3650-M2 (single E5504, 146GB HDD) with 4GB RAM. I am getting an error message that this hardware in incompatible. In short its not passing hardware val...
Hi Nick,
Change the DTMF profile on the SIP trunk to VCS, I changed the DTMF signaling method to OOB and RFC 2833 which worked. I had tried enabling Early Offer "Best Effort - insert MTP if required" in the past but did not work.
Thank you for th...
Hi Joe,
\
I am facing the same issue. I need the same SIP trunk to do both audio and video calls from the telepresence room. The call flow is starting from the call manager and then going in through the SIP trunk to VCS.
When I am enabling require ...
Thank you for your feedback, I was successfully able to get the release keys for the codec so that I could upgrade to the latest firmware which fixed the issue. I think the Tandberg codec's which are running earlier firmware versions are not compatib...
FYI,
I spoke to Cisco and was able to get the release keys for one of the codecs and then upgrade the firmware to TC7.3.11.c1479a9 which resolved the issue, now I am able to connect calls with Cisco WebEx using CMR without any issues.
Thank you.
FYI,
I spoke to Cisco and was able to get the release keys for one of the codecs and then upgrade the firmware to TC7.3.11.c1479a9 which resolved the issue, now I am able to connect calls with Cisco WebEx using CMR without any issues.
Thank you.
