cbeswick
Level 1
Level 1
Member since ‎09-19-2004
‎06-27-2018

User Statistics

  • 267 Posts
  • 0 Solutions
  • 39 Helpful votes Given
  • 16 Helpful votes Received

User Activity

Hi, Is it possible to use the native 40GE ports on the N7K-M206FQ-23L module for the VPC Peer Link, or do you have to break these ports out into 10GE ? I have read that 10GE ports must be used for the VPC peer link. Thanks in advance.
Hi,We are thinking of using manual CTS encryption on either natively routed ports, or Vlans / SVIs  (Nexus 7ks) to form OSPF adjacencies, but need to understand if this will work across a providers QinQ network. It is my understanding that Trustsec e...
Dear All,Has anyone had any experience using the new "Trust Communication" feature in ACS 5.5 ?I am wanting to know if this will work with self signed certs, or even a public wildcard cert, i.e. *.domain.comI have tried exporting the self signed cert...
Hi,I am currently trialing ACS 5.5. I have two ACS instances which I want to configure as a primary / secondary but whenever I try to register the secondary node to the primary, I get the following message:"This System Failure occured: Registration f...
Hi,I need to configure tacacs to communicate with ACS 5.4 over the "FastEthernet 0" port on a Cisco 3560X. Is this possible using the"ip tacacs source-interface FastEthernet0" command ?All other IP Interfaces are public facing and we need to get AAA ...
Community Statistics
Member Since ‎09-19-2004 03:32 AM
Date Last Visited ‎06-27-2018 12:18 AM
Posts 267
Total Helpful Votes Received 16
Helpful Votes From
Helpful Votes Given To