Hi, Somebody please explain me what is the actual purpose native vlan in real scenarios.I have ready many documents related native vlan and I know it will never tag the vlans.But I want to know in which situation configure native vlan in our real ...
Hi... Could anyone clarify my doubt. My doubt is while we configuring serial interface for wan connection we use encapsulation method .What is the use of it?.why we don't use encapsulation command in ethernet interface?Thankyou
haii everybody, Suppose we have two layer2 switches(2960) and one multi layer switch(catalyst3560) .These two layer2 switches carry 3 vlans (vlan20,vlan30,vlan40).and there is no router or other layer 3 device .with these devices is it possible t...
haii, I am a CCNP student .While I was trying to make an ibgp network by interconnecting 3 routers seriely(R1------R2-----R3) with basic configuration.Then R1 and R2 & R2and R3 became neigbours its states shows as established.The problem is that no...
haii everybody, I would like to know ,how can I allocate time slot ,if I need only 10 channel to be activated for PRI at T1 .could anybody pls explain shortly and give sample commands .
Hi vasanthmanoharan,
I think this document will you help you out in this..
http://www.cisco.com/c/en/us/support/docs/switches/catalyst-2950-series-switches/24042-158.html
Regards
Prajith
I believe it allow the reverse telnet traffic (10.10.10.1 to 10.1.1.9)only once the forward connection(10.1.1.9 to 10.10.10.1) is established. RegardsPrajithTR
Please refer this doc for configuring ssh .http://www.cisco.com/c/en/us/support/docs/security-vpn/secure-shell-ssh/4145-ssh.html Define these ip address in a access-list and call that access-class into line vty . RegardsPrajithTR
Make MTU size of both routers(Both cisco and juniper)same.Mostly Stuck in neighbour forming in Exstart/Exchange state is due to MTU mismatch Referencehttp://www.cisco.com/c/en/us/support/docs/ip/open-shortest-path-first-ospf/13684-12.html#neighbors R...
